Kart Simulator Hardware - Cockpit Setups

[SimRacer]

Thanks. Kinda, this is a gyro from a BMX, but I have to make a mounting solution for it.

[EVO]

make sure you put the bracket on the shaft so the tie ronds still move the real wheels wouldnt that be sweet

[SimRacer]

make sure you put the bracket on the shaft so the tie ronds still move the real wheels wouldnt that be sweet

Haha, that would be cool. Too bad I dont have the rims and tyres for it.

Progress has slowed a little on the project due to that old excuse called "a job", but I recently got a great deal on some G25 and G27 parts for the project so I will get back into the task of mounting the G25 steering motor soon.

[Eslotes]

news?

[Eslotes]

up

[robby]

First I say hello
I am new to this forum and would like to show my cocpit
to everyone.
It is made ​​of aluminum 45x45 mm
The steering wheel is fanetec
  the pedals and shift lever also
I have everything connected to an acer projector
regards Robby

[img=http://img39.imageshack.us/img39/3864/1003552s.th.jpg]
[img=http://img189.imageshack.us/img189/9404/1003551n.th.jpg]
[img=http://img828.imageshack.us/img828/7031/1003550y.th.jpg]

[SimRacer]

Have not had a lot of time to work on this project so this is only a small update. Installed an apelectrix load cell in the brake. Also mounted the throttle and cable to run it. Throttle and clutch mounting and adjustment system are still a work in progress, so is the clutch.

[Eslotes]

up

[EVO]

that method for the pedals looks better than mine.  More direct

[Eslotes]

Some news SimRacer ?

[Dan Buck]

yeah!! that was a good up thread eslotes! thanks!

[DPKarter#43]

Hows the project going?

[Delano/SM]

Does someone know whats the best setup for clutch release?  (i currently use smooth and 100)

[Dan Buck]

hey SimRacer, how is your project going??
news? pics? please don't forget about us!

[Eslotes]

SimRacer profiel:
Last Active: April 03, 2012, 04:01:25 AM