• Welcome to Kart Racing Pro Official Forum. Please login or sign up.
 
March 28, 2024, 02:09:21 PM

News:

Kart Racing Pro release13e available! :)


Flip on turn in... Beta 12

Started by Ryan Harris, January 02, 2015, 05:15:49 AM

Previous topic - Next topic

Ryan Harris


Cory_Hayes

I am having issues bottoming out, when my ride height is higher than standard...and it still scrapes on turn in.
I have managed to bottom out and flip many times :/

Ryan Harris


Myles Rowe Top Kart #6

Sincerely,

Myles Rowe

Cory_Hayes

This problem should definitely be fixed...

Marco Dakic

3D Modeling :D

Tr!st@n

Yes. Had the same issue but with the right setup it works.
FA Kart - IAME X30 Senior

Birel-Rotax 42


Cory_Hayes

I did change my ride height, I was running higher than high, and I still manage to scrape.

Myles Rowe Top Kart #6

I did some testing with the birel kf3 having the same problems but managed to figure it out. I don't know if it will work for crg and tony but its worth a try. (the measurements are uk) Here's the setup:
Under Chassis:
rear axle= 50 soft
front crash bar=tight
front bar= vertical
middle bar=-
side pod bars= tight
rear bar= out
rear crash bar= tight
front hubs= mg 75mm
rear hubs= mg 77mm
seat mount= tight
seat horizontal= 66.0 cm
seat vertical= 1.0 cm
seat stays= 2
Under other:
ratio= std
ackermann= std
caster=26.0 deg
camber= 4mm
front pressure= 9.4 psi
front ride height= 4.5 cm
toe out= 2mm
front track width= 1220 mm
rear pressure= 12.3 psi
rear ride height= 4.5
rear track width= 1350 mm
I hope this helps a lot.
Sincerely,

Myles Rowe

Marco Dakic

i drive in front 2,5cm and rear 3,0cm ride height without any problems lol :D
3D Modeling :D

Cory_Hayes

Maybe I just drive so hard and well, that I flex the crap out of the chassis...because no matter what I do, I am getting the kart to scrape, I can still put down a really good time, I just have to be careful.

Birel-Rotax 42

Raising the ride heights has worked for me, and I have gone fastest at Lonato. Change your driving style.

Cory_Hayes


Marco Dakic

Yes Cory Please learn, Clean Driving :D
3D Modeling :D