Track only visible from under

[christianbruus]

When i open the 3d file in a normal 3dviewer it looks fine but when i have converted it and open it in "mapwiew" i can only see the track if i go below 0 and look up at it, i cant see it from above. that also aplies to tracked i can not see the track in there only the ground surface

[LXS77]

Sounds like inverted faces. Just flip the normals.

[christianbruus]

Sounds like inverted faces. Just flip the normals.

where/how do i do that

[LXS77]

You can do it in the 3d editor in which you're creating the track. How to do it depends on the software you're using, just google it.

[christianbruus]

You can do it in the 3d editor in which you're creating the track. How to do it depends on the software you're using, just google it.

Thank you sir, that was the problem it is now fixed.
thank you for your time

[LXS77]

No worries!