• Welcome to Kart Racing Pro Official Forum. Please login or sign up.
 
March 29, 2024, 09:11:01 AM

News:

Please read the FORUM RULES


Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Keagan

1
I've got good spark. Carb settings are:  H. 1/8 turn out.  Low is 1 full turn, based on Walbro factory rebuild instructions
2
Bought the kart for my grandson to step up from the yard kart. He was power sliding it since he was 5🌝
Previous owner said hasn't been started for "several years". 
I've drained the tank, filled with 50/1 mix
Initially disassemble the carb: all parts looked good, cleaned in ultrasonic unit, but still no start.
Bought new kit,, installed all new diaphragms etc, no start
will fire with a shot of premix into the air cleaner
New plug ,  got good rich fire
Compression test reads 60 psi
Plug looks "wet" after attempts to start
I note that the H needle does not have the o ring, washer that shows in manual ( did not come in new kit either)
I'm new to these little 2 strokes, but pretty experienced wrench over all
Any thoughts?   
Located in Southern In.