Messages

It is important to correctly setup the steering wheel.

1 ) In the steering wheel profiler, disable the centering spring and damping, or at least let the software override them.
2 ) Take note of the rotation ( the suggested value is 180 ).
3 ) Start Kart Racing Pro and click on Settings -> Input -> Calibration.
4 ) Move all the inputs to their full extent.
5 ) If you have other controllers connected as a separate device, select them from the dropdown menu at the top of the calibration screen.
6 ) Repeat from 4) until all controllers have been calibrated at the same time
7 ) Then leave all inputs of all controllers perfectly centered / released before pressing "Ok".
8 ) Click on the right of Controls -> Steer and steer LEFT to assign the control.
9 ) Under Advanced -> Steer, set deadzone to 0, linearity to 100 and leave smooth unchecked.
10 ) Enable force feedback and set strength to 100%, deadzone to 0% and linearity to 100%
11 ) Enable wheel rotation and set it directly or use the wizard. In both cases the value should match the rotation set in the profiler.

12 ) If you are experiencing vibration on straights, please try increasing force feedback deadzone in steps of 5. This shouldn't be needed on the Logitech G25 and G27.
13 ) If you feel the force in the center is a bit weak, you can try lowering the force feedback linearity.

This is how the FF curve looks like at 0 ( top ) and 100 ( bottom ) linearity:

Hi, I have a Thrustmaster T300RS and have follow your instructions on the setting.  However, the wheel keeps on turning left and right itself even when the kart stops? What setting do I need to adjust?