When I click on krp when using my TV as a screen it just goes off (computer still on) and screen is just off but when I move the mouse I can hear the sounds of me selecting something
when you restart it(pc):
1. check pc bios- f4 or f8 key b4 checksum starts
A. record all previous settings
B. in bios look for video settings and see if any changes are needed.
C. make sure changes are set and saved in bios
2.Run boot up as normal
A. from desktop- right click desktop screen and click properties
B. look for monitor tab and check where video output is going
C. if vid card offers an icon on control panel, check there for monitor settings
3. using tv remote control or equivalent
A. go to tv's settings menu
1. make u have the right input set- many tvs have a pc setting.
2. cable makes a big difference- so match the tv to your cable if using a setting other than pc
Good luck
Quote from: Racer80 on January 02, 2016, 04:45:27 PM
When I click on krp when using my TV as a screen it just goes off (computer still on) and screen is just off but when I move the mouse I can hear the sounds of me selecting something
Is your TV screen 1080p (assuming you pc screen is)?
If so, lower your resolution before connecting to the TV (720p should do it) and give it a go.
Also most tvs operate at 60hz. From experience i recommend that setting regardless of advertised 120hz capability.
Quote from: 3rd.Rail on January 03, 2016, 12:36:46 PM
Also most tvs operate at 60hz. From experience i recommend that setting regardless of advertised 120hz capability.
Most monitors are 60hz as well so it wont make a difference.
Thanks for the help on this guys