Title explains the issue. ???
I am having issues bottoming out, when my ride height is higher than standard...and it still scrapes on turn in.
I have managed to bottom out and flip many times :/
yeah bottoming out aswell.
Same.
This problem should definitely be fixed...
Change the ride height and setup ;)
Yes. Had the same issue but with the right setup it works.
Hot fix: Change the ride height.
I did change my ride height, I was running higher than high, and I still manage to scrape.
I did some testing with the birel kf3 having the same problems but managed to figure it out. I don't know if it will work for crg and tony but its worth a try. (the measurements are uk) Here's the setup:
Under Chassis:
rear axle= 50 soft
front crash bar=tight
front bar= vertical
middle bar=-
side pod bars= tight
rear bar= out
rear crash bar= tight
front hubs= mg 75mm
rear hubs= mg 77mm
seat mount= tight
seat horizontal= 66.0 cm
seat vertical= 1.0 cm
seat stays= 2
Under other:
ratio= std
ackermann= std
caster=26.0 deg
camber= 4mm
front pressure= 9.4 psi
front ride height= 4.5 cm
toe out= 2mm
front track width= 1220 mm
rear pressure= 12.3 psi
rear ride height= 4.5
rear track width= 1350 mm
I hope this helps a lot.
i drive in front 2,5cm and rear 3,0cm ride height without any problems lol :D
Maybe I just drive so hard and well, that I flex the crap out of the chassis...because no matter what I do, I am getting the kart to scrape, I can still put down a really good time, I just have to be careful.
Raising the ride heights has worked for me, and I have gone fastest at Lonato. Change your driving style.
ok hahahaha
Yes Cory Please learn, Clean Driving :D